Xerox XES 8855 manual Manual Bypass Feed

Page 21

MANUAL BYPASS FEED

The bypass feed mode is used when the print, which is being sent to the printer, is a different size than the roll media loaded in the printer.

For example:

You want to send a C size print, but there is no C size media loaded in the printer. You can use the bypass feed mode to run the C size print, using cut sheet media.

When the correct media is not loaded for an incoming print, the Status Display shows the

flashing code P-05.

1.Adjust the paper guides to the correct size.

2.Feed the cut sheet media squarely into the printer, curl side down and between the guides, until the media stops.

The Status Display indicates the size when the media is loaded (05-xx).

15

Manual Bypass

Image 21
Contents XES 8855 Printer User Guide EMC Notices USA Trademark Acknowledgments Safety Notes Safety notes Table of Contents Safety Notes Safety Notes Ground Fault Protection Front View Printer OverviewRear View Right Side View Page Loading the Media Rolls 1, 2 Media InformationRoll 3 only Loading the Media Roll Media Information Making a Test Print Dehumidifier Manual Bypass Feed Page Status Indicators Problem SolvingCodeCause/What to Do Error CodesProblem Solving Top Drawer is not closed. Open and close Media Jam J-01, J-02 Clearing the Media PathMedia Jam J-03 Media Jam J-04 Media Jam J-05 Media Jam J-11 Media Jams J-12, J-13 Media Jam J-14 Page Replacing the Toner Cartridge CareCare Replacing the Toner Waste Container Replacing the Oil Pads Cleaning the Upper Corotron Cleaning the Lower Corotron XES Product SpecificationsPower Consumption Conformité EEM au Canada FCC Compliance in the USA EME Compliance in Canada701P9241412/00