Xerox XES 8855 manual Cleaning the Lower Corotron

Page 40

CARE

Cleaning the Lower Corotron

34

Periodic cleaning of the corotron will reduce print quality problems caused by accumulation of toner inside the printer.

CAUTION

Use care when removing and replacing the corotron to avoid scratching the photosensitive drum inside the printer. Do not force the corotron in or out of

the printer.

1.Switch off the power to the printer.

2.Open the right side cover.

3.Locate instruction label (2) and follow the instructions to remove and replace the lower corotron: (2).

5.Lay the corotron on a flat surface to expose the corotron wires for cleaning.

6.Clean the corotron wires using a lint-free cloth dampened with water.

7.Rub the wires gently from end to end until most of the toner is removed.

8.Allow the corotron to dry before replacing.

Image 40

Contents XES 8855 Printer User Guide EMC Notices USA Trademark Acknowledgments Safety Notes Safety notes Table of Contents Safety Notes Safety Notes Ground Fault Protection Printer Overview Front ViewRear View Right Side View Page Media Information Loading the Media Rolls 1, 2Roll 3 only Loading the Media Roll Media Information Making a Test Print Dehumidifier Manual Bypass Feed Page Problem Solving Status IndicatorsError Codes CodeCause/What to DoProblem Solving Top Drawer is not closed. Open and close Clearing the Media Path Media Jam J-01, J-02Media Jam J-03 Media Jam J-04 Media Jam J-05 Media Jam J-11 Media Jams J-12, J-13 Media Jam J-14 Page Care Replacing the Toner CartridgeCare Replacing the Toner Waste Container Replacing the Oil Pads Cleaning the Upper Corotron Cleaning the Lower Corotron Product Specifications XESPower Consumption FCC Compliance in the USA EME Compliance in Canada Conformité EEM au Canada701P9241412/00