Xerox 721P83071 manual Shows the 4635 LPS with the optional bypass transport

4635 LPS HARDWARE COMPONENTS

High-capacity feeders (HCF)Ð trays 3, 4, 5, and 6 (5 and 6 optional)

High-capacity stackers (HCS)Ð bins A, B, C, and D (C and D optional)

Sample tray

Purge tray

Printer control console

Optional bypass transport

Optional input enablement device

Trays 1 and 2 can handle paper sized from 8 by 10 inches to 9 by 14 inches/203 by 254 mm to 229 by 356 mm.

Each HCF can hold up to 2,600 sheets of 20-pound/75-gsm paper as small as 7 by 10 inches and including large paper sizes such as 11.69 by 16.54 inches (A3), 11 by 17 inches (297 by 432 mm), and 10.12 by 14.33 inches (B4).

Each HCS can hold up to 2,500 sheets of 20-pound/75-gsm paper, if a stacking container is not used. Printed sets can be offset in the HCS for easier separation of reports.

The capacity of the sample tray is 100 sheets of 20-pound/75-gsm paper.

The purge tray located at the top of the last feeder/stacker module is where waste sheets are sent when cleared from the printer. The purge tray can hold 100 sheets of paper.

The printer control console located on top of the printer contains the continue, stop, and sample buttons. The console has a color monitor with a touch-sensitive screen which displays detailed graphics showing jam clearance instructions and feeder/stacker status. Printer tasks, such as lowering feeder trays and stacker bins, can be performed by touching areas of the console screen.

The ability to increase your production capability by adding finishing devices to your 4635 is made possible by the Bypass Transport option. Finishers give you the ability to choose a wide range of finishing options, such as shrink wrapping and stitching. The bypass transport processes simplex and duplex jobs and accepts any type of paper that your 4635 LPS is capable of handling (refer to the ª4635 LPS overviewº chapter).

Connected to the feeder/stacker, the bypass transport allows finishing devices to interface directly with your 4635 LPS. It is fully integrated into your 4635 LPS hardware and software utilities, allowing you to select it at the UI or within your job setup. The bypass transport meets the Xerox Document Feeding and Finishing Architecture (DFA) Level 1 specifications.

The input enablement device is connected to the right side of the feeder/stacker module and provides the means to add bulk feeders to your 4635 LPS. Fully integrated into your 4635 LPS hardware and software utilities, your input enablement device is selectable at the UI or within your job setup.

Figure 3-7 shows the 4635 LPS with the optional bypass transport.

3-6 XEROX 4635 LASER PRINTING SYSTEM PRODUCT REFERENCE