Xerox Nuvera® 100/120/144 EA Digital Production System - Customer Expectations Document
performance with each technology. Xerox papers and specialty media are digitally optimized (paper specs - smoothness, formation, electrical properties, etc., for optimal image quality, toner adhesion and performance, and also precision sheeted - less contamination, better registration for use in Xerox digital equipment.
•Two feed modules in tandem may be installed on the input side of the printer.
SPECIAL STOCKS
Carbonless
Xerox Carbonless Papers as listed in this document are the only recommended carbonless media. Only simplex printing is supported on this stock type. Running carbonless paper may require additional cleaning time by the CSE during service of the machine. This time will vary based on the percentage of carbonless stock run. In the 100% carbonless usage case, service time could be up to 60 additional minutes per service call at 150,000 prints
DocuCards®
DocuCards® can only be loaded 100 at a time in a tray. Nuvera® feeder trays feed until almost empty but not until empty, leaving 20~40 sheets remaining. When running DocuCards®, frequent reloading of the feeder trays will be required.
DocuCards® can only be run to the Top Tray of the finisher. Some mis-
stacking may occur as the DocuCards® catch on the edges of the stacked sheets®. When using DocuCards, it is recommended that you use a Tiltatron (available from CAS).
Reinforced stocks
Reinforced stocks such as Mylar tabs should be limited to 90 loaded in a tray at one time.
Transparencies
The tray capacity for removable stripe transparencies is 90 sheets. There is no constraint for feeding painted striped transparencies or stripeless transparencies.
Tab Jobs |
|
Running tabs requires proper use of the supplied Tab Guides. |
|
For configurations with the BFM or FTM, jobs should be run with straight |
|
collated tabs. For configurations with the MFF, jobs must be run with |
|
reverse collated tabs (the number of segments should be 10 or less). For |
|
the MFF configurations, please also refer to the Crucial Performance |
|
Expectations section for comments on ‘Drilled Paper and Tab jobs’. |
|
Tab stock sizes supported are: Letter, 9” x 11,” 9.5” x 11”, A4 |
Envelopes
Envelopes should be limited to 60 loaded in a tray at one time. Nuvera® feeder trays feed until almost empty but not until empty, leaving 20~40 sheets remaining. When running envelopes frequent reloading of the feeder trays will be required.
Very slight wrinkles (1/2 inch long) may occur on the trail edge of envelopes at the corners.
Due to the nature of feeding envelopes with flap open, some
Envelopes should be sent to the Top Tray only. For the MFF configurations, the maximum limit is 15.
- 35 -