TRENDnet BRF114 LAN Screen, Tcp/Ip, IP Address, Subnet Mask, DHCP Server, Buttons, Save, Cancel

TW100-BRF114 User’s Guide

LAN Screen

Use the LAN link on the main menu to reach the LAN screen. An example screen is shown below.

Figure 6: LAN Screen

Data - LAN Screen

TCP/IP

IP Address	IP address for the TW100-BRF114, as seen from the local LAN. Use
	the default value unless the address is already in use or your LAN is
	using a different IP address range. In the latter case, enter an unused IP
	Address from within the range used by your LAN.
Subnet Mask	The default value 255.255.255.0 is standard for small (class "C")
	networks. For other networks, use the Subnet Mask for the LAN
	segment to which the TW100-BRF114 is attached (the same value as
	the PCs on that LAN segment).
DHCP Server	• If Enabled, the TW100-BRF114 will allocate IP Addresses to PCs
	(DHCP clients) on your LAN when they start up. The default (and
	recommended) value is Enabled.
	• If you are already using a DHCP Server, this setting must be
	Disabled, and the existing DHCP server must be re-configured to
	treat the TW100-BRF114 as the default Gateway. See the follow-
	ing section for further details.
	• The Start IP Address and Finish IP Address fields set the values
	used by the DHCP server when allocating IP Addresses to DHCP
	clients. This range also determines the number of DHCP clients
	supported.
	See the following section for further details on using DHCP.
Buttons
Save	Save the data on screen.
Cancel	The "Cancel" button will discard any data you have entered and reload
	the file from the TW100-BRF114.

14