TRENDnet BRF114 Routing Screen, Enable RIP, Static Routing, Table Entries, Properties, Buttons

Other Features and Settings

Figure 45: Routing Screen

Data - Routing Screen

RIP

Enable RIP	Check this to enable the RIP (Routing Information Protocol) feature
	of the TW100-BRF114.
	The TW100-BRF114 supports RIP 1 only.
Static Routing
Static Routing	This list shows all entries in the Routing Table.
Table Entries	• The "Properties" area shows details of the selected item in the
	list.
	• Change any the properties as required, then click the "Update"
	button to save the changes to the selected entry.
Properties	• Destination Network - The network address of the remote LAN
	segment. For standard class "C" LANs, the network address is
	the first 3 fields of the Destination IP Address. The 4th (last)
	field can be left at 0.
	• Network Mask - The Network Mask for the remote LAN
	segment. For class "C" networks, the default mask is
	255.255.255.0
	• Gateway IP Address - The IP Address of the Gateway or
	Router which the TW100-BRF114 must use to communicate
	with the destination above. (NOT the router attached to the re-
	mote segment.)
	• Metric - The number of "hops" (routers) to pass through to
	reach the remote LAN segment. The shortest path will be used.
	The default value is 1.
Buttons
Save	Save the RIP setting. This has no effect on the Static Routing Table.
Add	Add a new entry to the Static Routing table, using the data shown in
	the "Properties" area on screen. The entry selected in the list is
	ignored, and has no effect.

73