Star Micronics SP2000 manual Code HEX Outline

FUNCTION

CODE

HEX

OUTLINE

Sets the memory switch

<ESC> “# N, n1 n2 n3 n4” <LF> <NUL>

1B 23 N 2C n1 n2 n3 n4 0A 00

In order to enable changed memory switch settings, turn the

printer OFF and ON again or send the printer reset command (<ESC> “?” <LF> <NUL>) to the printer. Changed memory switch settings are stored in EEPROM and these settings will be stored until they are changed again.

N:Memory switch number (“0,” “1,” “2,” “3,” “4,” “5,” “6”)

n1 n2 n3 n4: Mode settings (For details see below.)

1)N = 0 (Star mode) n1: Always “0”

n2: Always “0”

Parameter		Setting	“0” (Default)	“1”
n3		Destination	Standard	Asia Market
n4		FF command *1	See below
n4	<FF> command *1
“0” to “3”	Feeds page
“4” to “7”	Executes full cut after feeding paper to the cut
	position. (*2)
“8” to “B”	Feeds page
“C” to “F”	Executes partial cut after feeding paper to the cut
	position. (*2)

*1: Only on printers that have an auto-cutter (SP2520/2560).

*2: Paper feed to cutting position is executed in 1 inch incre- ments.

N = 0 (ESC/POS mode) n1: Always “0”

n2: Always “0”

n4: Always “0”

Parameter	Setting	“0” (Default)	“1”
n3	Destination	Standard	Asia Market

37