Star Micronics SP2000 manual Treatment of missing data during reverse mode

FUNCTION

CODE

OUTLINE

n2	Treatment of missing data during reverse mode
“0” to “7”	Store
“8” to “F”	Delete

*1: Valid only when using a parallel interface.

Set DIP SW 1-2 if you are using a serial interface.

Also, the conditions for BUSY and the automatic status are disregarded.

*2: Valid only when using a parallel interface.

For example, if you exit the reverse mode without the host receiving the trailing data of the automatice status the remainder of the status data will be handled as described below.

Store:	Stores the remaining data and transmits it at the
	next time the reverse mode is entered. If the
	automatic status occurs, the new status will be
	transmitted after that remaining data.
Delete:	Deletes the remaining data. It does not transmit
	that data the next time the reverse mode is
	entered. The new status data is transmitted from
	the header field.

Initialize printer

<ESC> “@”

(1B)H (40)H

Initializes all the commands already set. However the following

parameters are not initialized: online switch valid/invalid selection. Also, the line and data buffers are not cleared. The DIP switches and the memory switches are not read in again.

The select/deselect state for addressable mode and DC1/DC3 mode is not affected.

43