n4 | CR code |
“0” | Ignores |
|
|
“1” | Ignores |
|
|
“2” | Feeds line after printing (same as <LF> |
|
|
“3” | Prints (no line feed.) |
|
|
N = 3 (ESC/POS mode)
n1: Always “0”
n2: Always “0”
n3: Always “0”
Parameter | Setting | “1” to “3” |
n4 | CR code | See below |
n4
“0”
“1”
“2”
“3”
CR code
Prints (no line feed.)
Feeds line after printing (same as <LF>
(Parallel Interface)
Prints and feeds line when nAutoFd signal is “LOW”. Does not feed line when “HIGH.”
(Serial Interface)
Ignores
Ignores
5)N = 4 (Star mode) n3: Always “0”
Para. | Setting | “0” | “1” | “2” | “3” |
|
|
|
|
|
|
n1 | X on/X off Timing | When | Every 3 | When | Every 3 |
|
| Toggled | sec | Toggled | sec |
| RTS Signal Condition | Save as | Save as | Always | Always |
| DTR | DTR | SPACE | SPACE |
|
n2 | Receive buffer size | 4 kbytes | 4 kbytes | 256 bytes | 256 bytes |
n4 | Data receipt error | “?” | Ignored | “?” | Ignored |
|
| Printed |
| Printed |
|
41