Xantrex Technology C40R/50, C40R/100, DVM/C40, C40R/100 Remote manual Connecting the Faceplate

Page 17

1Remove these 4 screws to access circuit board.

2Remove this LED (pull out).

Faceplate (back)

RJ-15 Port

Plug the Serial Communication

3 Cable into RJ-15 Port on the circuit board.

4 & 5	Align the faceplate and
	replace the 4 screws.

Figure 6 Connecting the Faceplate

975-0123-01-01 Rev A

11

Image 17

Contents Series Meter Display Page Series Meter Display Date and Revision Contents Page Faceplate and Remote IntroductionImportant Safety Information Additional Safety Guidelines Faceplate and Remote Features FeaturesInformation Type Display Value/Range Liquid Crystal Display LCDLED Status Indicator Amp-Hour Reset and Backlight ButtonSee Jumper Installation on page 8 for instructions InstallationTo select and set the voltage Jumper Installation StepJumper Locations on the FacePlate and Remote To connect the Faceplate to the C-Series controller Cable Installation StepConnecting the Faceplate To connect the remote Connecting the Remote Minimum Clearance for the Remote Mounting the Remote Step16 116 mm To Mount the Remote Operation Status IndicatorTurning the Display Backlight On or Off TroubleshootingResetting the Amp-Hour Meter Warranty Warranty and ReturnTelephone Rev a Product DisclaimerExclusions Return Material Authorization Policy Return Procedure Other Xantrex Products Out of Warranty ServicePage Xantrex Technology Inc