Xantrex Technology C40R/50 Remote, C40R/100 Remote manual Connecting the Remote

1 Remove these			RJ-15	Remote (back)
			Port
4 screws to
access circuit
board.
2
Route one end of SCC through	3	Serial Communications Cable			4
			(SCC)
strain relief on controller.

Plug the SCC into the RJ-15 Port on the circuit board of the controller.

5

Mount the display up to 1,000 ft from the controller.

Route the other end of the SCC to the RJ-15 Port on the back of the Remote.

6Align the original faceplate and replace the 4 screws.

Figure 7 Connecting the Remote

975-0123-01-01 Rev A 13