Important: The green and red color of the LED only indicates the particular operating mode and the battery voltage level. It does not indicate whether the charging source is functioning properly.
4 Installation
The following sections describe how to install the
1.Jumper Installation (Step 1): Set the voltage setting on the faceplate or remote to match the system voltage by installing the jumper over the appropriate pins. This step is critical to the proper operation of the unit.
See “Jumper Installation (Step 1)” on page 8 for instructions.
2.Cable Installation (Step 2): Connect the display to the
See “Cable Installation (Step 2)” on page 10 for instructions.
3.Faceplate/Remote Installation (Step 3): Determine the location and mounting method for the remote (if used).
See “Mounting the Remote (Step 3)” on page 14 for instructions.
7 |