Xantrex Technology C40R/100 Remote, C40R/50 Remote Troubleshooting, Resetting the Amp-Hour Meter

Page 24

Resetting the Amp-Hour Meter

To manually reset the amp-hour meter, press and hold the push-button on the front of the meter until the display resets.

The meter automatically resets if power is disrupted (for example, DC cable is removed and replaced).

Turning the Display Backlight On or Off

Press and release the Amp-hour Reset button to turn the backlight on or off.

6 Troubleshooting

If using long cable runs on the remote (greater than 100 feet) or if the meter seems inaccurate, remove the jumper located below the voltage configuration pins on the circuit board on the back of the unit. This dims the LCD backlight, reduces power consumption, and improves meter accuracy.

See the Owner’s Manual for the C-Series Multifunction DC Controller for additional information about Troubleshooting.

18	975-0123-01-01 Rev A

Image 24

Contents Series Meter Display Page Series Meter Display Date and Revision Contents Page Introduction Faceplate and RemoteImportant Safety Information Additional Safety Guidelines Features Faceplate and Remote FeaturesLiquid Crystal Display LCD Information Type Display Value/RangeAmp-Hour Reset and Backlight Button LED Status IndicatorInstallation See Jumper Installation on page 8 for instructionsJumper Installation Step To select and set the voltageJumper Locations on the FacePlate and Remote Cable Installation Step To connect the Faceplate to the C-Series controllerConnecting the Faceplate To connect the remote Connecting the Remote Mounting the Remote Step Minimum Clearance for the Remote16 116 mm To Mount the Remote Status Indicator OperationTroubleshooting Resetting the Amp-Hour MeterTurning the Display Backlight On or Off Warranty and Return WarrantyTelephone Rev a Disclaimer ProductExclusions Return Material Authorization Policy Return Procedure Out of Warranty Service Other Xantrex ProductsPage Xantrex Technology Inc