3.5Firmware upgrade.
If firmware needs to be changed, alternative firmware can be downloaded.
Please contact
These steps only work for a serial connection, look further down how to do it with USB.
1.Power the system off.
2.Disconnect printer.
3.Short circuit the pins “upgrade firmware”
4.Turn on printer
5.Write the following command “mode com1:9600,n,8,1”, this command ensure that the serial port is at a known state.
6.Write the following command “xmode 1 +”, this command sets the baud rate to 115.200, the xmode program can be downloaded from the
7.Run the following command, “copy “filename” /b com1”. The filename represents the path and the filename of the new firmware file. This file can be downloaded from website, or can be emailed by
For further information about downloading with the driver, can be found in the driver installation guide.
3.6Auto form feed
When paper no paper is present, it is possible to form feed new paper automatic. While thermal head is down, place the paper at the roller. After 2 seconds (default) the paper will be pulled in automatically. Form feed wait time is 2 sec (default), but can be changed by a command.