Fujitsu PRN608-S user manual Led

PRN608-S

The paper near end status, can be seen on the LED on the aux connector, it can be reading through the status command, and if a driver is used, then it can be reading in the port monitor: If paper jam is used, then will the printer stop printing if this signal is going low, the value of this bit can be seen on the LED on the aux output connector, it can be reading by a status request, or if a driver is used, then it can be reading by the port monitor

The paper near end and paper jam is indicated on LED at the AUX connector CN4. The status of these bits can also be read with a response on a status request. If a driver is used, then the status can also be read in the print monitor. If paper jam sensor is activated printing will stop until paper jam sensor is deactivated. The LED will show these conditions.

The LED will show these conditions

LED	Error
Off	No Error
Flash 1Hz	Paper near end
Flash 2Hz	Paper jam
On	Both paper jam and near end

6.1.6 Power connector

Power connector CN7: 43045-0400

Mating connector

TBA

Pin	Function	Pin	Function
1	GND	3	GND
2	+8.5V	4	+8.5V

6.1.7 USB connector

USB connector CN5: UBBR-04SW11 Mating connector:

28-03-2003 Page 6-41 of 53