| 3.8.18 | Italic off | ||
| 3.8.19 | Italic on | ||
| 3.8.20 | Initialise Printer | ||
| 3.8.21 | Request Software version | ||
| 3.8.22 | Request Status | ||
| 3.8.23 | Request Analog voltage | ||
| 3.8.24 | Request Temperature | ||
| 3.8.25 | Sub command set | ||
| 3.8.26 | Upgrade command | ||
| 3.8.27 | Set auxiliary output | ||
| 3.8.28 | Automatic sending status | ||
| 3.8.29 | Stop sending automatic status | ||
| 3.8.30 | Color/Grey scale graphic | ||
| 3.8.31 | Enable saving data | ||
| 3.8.32 | Save data to board | ||
| 3.8.33 | Change dot size | ||
| 3.8.34 | Change form feed length | ||
| 3.8.35 | Change baud rate | ||
| 3.8.36 | Change form feed time | ||
| 3.8.37 | Feed Paper | ||
| 3.8.38 | Compensate Burn time | ||
| 3.8.39 | Bar code width setting | ||
| 3.8.40 | Bar code height setting | ||
| 3.8.41 | Bar code printing | ||
| 3.8.42 | Black Mark | ||
| 3.8.43 | Graphic data – non compressed | ||
| 3.8.44 | Graphic data – compressed | ||
| 3.8.45 | Escape sequences, overview | ||
4 | MAINTENANCE | |||
| 4.1 | DAILY USE | ||
| 4.2 | STORE/TRANSPORT | ||
5 | SPECIFICATIONS | |||
| 5.1 | ELECTRICAL DATA | ||
| 5.2 | MECHANICAL DATA | ||
| 5.3 | ENVIRONMENTAL DATA | ||
| 5.4 | EMC & ESC | ||
| 5.5 | TEMPERATURE TEST | ||
6 | CONNECTOR PIN ASSIGNMENT | |||
| 6.1.1 | Thermal Head connector | ||
| 6.1.2 | Thermal Head connector | ||
| 6.1.3 | IRDA connector | ||
| 6.1.4 | Cutter connector | ||
| 6.1.5 | AUX INPUT connector | ||
| 6.1.6 | Power connector | ||
| 6.1.7 | USB connector | ||
| 6.1.8 | AUX connector | ||
| 6.1.9 | Serial connector | ||
| 6.2 | MECHANICAL DRAWINGS | ||
7 | APPENDIX | |||
| 7.1 | SEIKO COMPATIBLE COMMAND SET (OPTIONAL) | ||
| 7.1.1 | Escape sequences, overview | ||
| 7.2 | FUJITSU COMPATIBLE COMMAND SET (OPTIONAL) |