Fujitsu user manual PRN608-S Stop sending automatic status Name Format

PRN608-S

3.8.29 Stop sending automatic status
[Name]	Stop sending automatic status
[Format]	ASCII	ESC b
	Hex	1B	62
	Decimal	27	98
[Description]	When this command is sent then it will turn
	off transmitting status.
3.8.30 Color/Grey scale graphic
[Name]	Colour / Grey scale graphic
[Format]	ASCII	ESC c		n
	Hex	1B	63	n
	Decimal	27	99	n
[Description]	When this command is sent then will the
	board not feed. After the next graphic data
	(both compression and not). The n is a
	percent of the burn ratio, n can be from 0 to
	15, and the burn ratio is 100/15*n. This
	command is used by the driver to make
	colour and grey scales printout.
3.8.31 Enable saving data
[Name]	Enable saving data
[Format]	ASCII	ESC d
	Hex	1B	64
	Decimal	27	100
[Description]	This command will enable that the boards
	save values to the flash, this is made to

ensure that a wrong transmission not will change settings in the board, remember to send the command “Saving data to board”, to actual save the data.

3.8.32 Save data to board
[Name]	Save data to board
[Format]	ASCII	ESC e
	Hex	1B	65
	Decimal	27	101
[Description]	This command saves all settings to flash.

28-03-2003 Page 3-27 of 53