Important Alert Items
Important Alert Messages
The important alert messages in this manual are as follows:
A hazardous situation could result in minor or moderate personal injury if the user does not perform the procedure correctly. This alert signal also indicates that damages to the product or other property may occur if the user does not perform the procedure correctly.
Task | Alert message | Page |
Mounting Installation | Data loss | |
| The drive adopts |
|
| The |
|
| performed in each sector where the maximum number of errors |
|
| (up to 9 byte) can be corrected. [Total maximum byte: 9 byte ⋅ 3 |
|
| ( interleave) = 27 byte] |
|
| If the error of read sector keeps allowable error byte number, |
|
| correction is performed. |
|
| However, if error byte exceeds its allowable number, correction |
|
| may not be performed properly. |
|
| Hot temperature |
|
| To prevent injury, do not handle the drive until after the device has | |
|
| |
| cooled sufficiently after turning off the power. The DE and LSI |
|
| become hot during operation and remain hot immediately after |
|
| turning off the power. |
|
| Data loss | |
| 1. The user must not change the setting of terminals not described | |
| in this section. Do not change setting status set at factory |
|
| shipment. |
|
| 2. Do not change the setting of terminals except following setting |
|
| pins during the power is turned on. |
|
| • Write protect: CN2 |
|
| 3. To short the setting terminal, use the short plug attached when |
|
| the device is shipped from the factory. |
|
Damage |
1.Make sure that system power is off before connecting or disconnecting cables.
2.Do not connect or disconnect cables when power is on.(except NC model)
v |