Fujitsu MAT3147NC/NP, MAT3300NC/NP, MAT3073NC/NP manual Task Alert message Mounting Installation

Task		Alert message	Page
Mounting Installation	Damage		5-12

1.Be careful of the insertion orientation of the SCSI connectors. With the system in which terminating resistor power is supplied via the SCSI cable, if the power is turned on, the overcurrent protection fuse of the terminating resistor power supplier may be blown or the cable may be burnt if overcurrent protection is not provided.

When the recommended parts listed in Table 4.2 are used, inserting the cables in the wrong direction can be prevented.

2.To connect SCSI devices, be careful of the connection position of the cable. Check that the SCSI device with the terminating resistor is the last device connected to the cable.

Data loss		6-4
When the SEND DIAGNOSTIC command terminates with the
CHECK CONDITION status, the INIT must collect the error
information using the REQUEST SENSE command. The RECEIVE
DIAGNOSTIC RESULTS command cannot read out the error
information detected in the self-diagnostics.
Caution		6-5
1.	To avoid shocks, turn off the power before connecting or
	disconnecting a cable, connector, or plug.
2.	To avoid injury, do not touch the mechanical assembly during
	disk drive operation.
3.	Do not use solvents to clean the disk drive.

Caution 6-6

1.Always ground yourself with a wrist strap connected to ground before handling. ESD (Electrostatics Discharge) may cause the damage to the device.

2.To prevent electrical damage to the disk drive, turn the power off before connecting or disconnecting a cable, connector, or plug.

3.Do not remove a PCA. This operation is required to prevent unexpected or unpredictable operation.

4.Do not use a conductive cleaner to clean a disk drive assembly.

5.Ribbon cables are marked with a colored line. Connect the ribbon cable to a cable connector with the colored wire connected to pin 1.

Damage	6-6
Never open the disk enclosure in the field. Opening the disk
enclosure may cause an irreparable fault.
Data loss	6-7
Save data stored on the disk drive before requesting repair. Fujitsu
does not assume responsibility if data is destroyed during servicing
or repair.

vi C141-E201