Fujitsu MAT3073NC/NP manual Cable connector requirements, Recommended components for connection

4.3.3Cable connector requirements

Table 4.2 lists the recommended components cable connection.

Table 4.2 Recommended components for connection

Applicable		Name	Par number	Manufacturer	Reference
model			(Size)		(*1)
	SCSI connector		787311-1	Tyco Electronics
NC		Connector		AMP
	(CN1)
			87689-0001	Molex
		Cable socket	DHJ-PAC68-2AN	DDK
				Tyco Electronics
		(closed-end type)	786090-7
	SCSI cable (CN1)			AMP	S1
		Signal cable	UL20528-FRX-68-	Fujikura
			P0.635
		Cable socket housing	1-480424-0	Tyco Electronics
				AMP
	Power supply
				Tyco Electronics	S2
	cable (CN1)	Contact	170148-1
				AMP
NP		Cable	(AWG18 to 24)
		Cable socket housing	A3B-12D-2C	HIROSE
				ELECTRIC
	External operator
					S3
				HIROSE
	panel (CN1)	Contact	A3B-2630SCC
				ELECTRIC
		Cable	(AWG26 to 36)
		Cable socket housing	FCN-723J024/2M	FUJITSU
				TAKAMIZAWA
	External operator
					S4
				FUJITSU
	panel (CN2)	Contact	FCN-723J-G/AM
				TAKAMIZAWA
		Cable	(AWG28)
(*1) See Figure 4.22.

(1)SCSI cable

See Section 1.3, “Physical Requirements”, and Section 1.4, “Electrical Requirements”, in SCSI Physical Interface Specifications.

(2)Power cable

IDDs must be star-connected to the DC power supply (one to one connection) to reduce the influence of load variations.

(3)DC ground

The DC ground cable must always be connected to the IDD because no fasten tab dedicated to SG is provided with the IDD. Therefore, when SG and FG are connected in the system, it is necessary to connect SG and FG at the power supply or to connect SG of the power supply to FG of the system.

4-20 C141-E201