Fujitsu PG-FCS103, PG-FCS102, BX620 manual Event Log Messages, Windows System Event Log messages

4.9Event Log Messages

4.9.1Windows System Event Log messages

The known base and intermediate Windows System Event Log status messages for this product are listed in "4.9.2 Base Driver (Physical Adapter/Miniport)" (Jpg.151) and "4.9.3 Intermediate Driver (Virtual Adapter/Team)" (Jpg.153). As a Broadcom adapter driver loads, Windows places a status code in the system event viewer. There may be up to two classes of entries for these event codes depending on whether both drivers are loaded (one set for the base or miniport driver and one set for the intermediate or teaming driver).

4.9.2Base Driver (Physical Adapter/Miniport)

"• Base Driver Event Log Messages" (Jpg.151) lists the event log messages supported by the base driver, explains the cause for the message, and provides the recommended action.

• Base Driver Event Log Messages

Message	Message	Cause	Corrective Action
Number
1	Failed to allocate memory	The driver cannot allocate	Close running applications
	for the device block.	memory from the	to free memory.
	Check system memory	operating system.
	resource usage.
2	Failed to allocate map	The driver cannot allocate	Unload other drivers that
	registers.	map registers from the	may allocate map
		operating system.	registers.
3	Failed to access	The driver cannot access	For add-in adapters: reseat
	configuration information.	PCI configuration space	the adapter in the slot,
	Reinstall the network	registers on the adapter.	move the adapter to
	driver.		another PCI slot, or
			replace the adapter.
4	The network link is down.	The adapter has lost its	Check that the network
	Check to make sure the	connection with its link	cable is connected, verify
	network cable is properly	partner.	that the network cable is
	connected.		the right type, and verify
			that the link partner (for
			example, switch or hub) is
			working correctly.
5	The network link is up.	The adapter has	Informational message
		established a link.	only.
			No action is required.
6	Network controller	The adapter has been	Informational message
	configured for 10Mb half-	manually configured for	only.
	duplex link.	the selected line speed and	No action is required.
		duplex settings.

E

4 Broadcom Gigabit Ethernet Teaming Services 151