Fujitsu PG-FCS102, PG-FCS103 manual 152, Duplex settings Medium not supported, Reboot the operating

Message	Message	Cause	Corrective Action
Number
7	Network controller	The adapter has been	Informational message
	configured for 10Mb full-	manually configured for	only.
	duplex link.	the selected line speed and	No action is required.
		duplex settings.
8	Network controller	The adapter has been	Informational message
	configured for 100Mb	manually configured for	only.
	half-duplex link.	the selected line speed and	No action is required.
		duplex settings.
9	Network controller	The adapter has been	Informational message
	configured for 100Mb	manually configured for	only.
	full-duplex link.	the selected line speed and	No action is required.
		duplex settings.
10	Network controller	The adapter has been	Informational message
	configured for 1Gb half-	manually configured for	only.
	duplex link.	the selected line speed and	No action is required.
		duplex settings.
11	Network controller	The adapter has been	Informational message
	configured for 1Gb full-	manually configured for	only.
	duplex link.	the selected line speed and	No action is required.
		duplex settings.
12	Medium not supported.	The operating system does	Reboot the operating
		not support the IEEE	system, run a virus check,
		802.3 medium.	run a disk check (chkdsk),
			and reinstall the operating
			system.
13	Unable to register the	The device driver cannot	Reboot the operating
	interrupt service routine.	install the interrupt	system; remove other
		handler.	device drivers that may be
			sharing the same IRQ.
14	Unable to map IO space.	The device driver cannot	Remove other adapters
		allocate memory-mapped	from the system, reduce
		I/O to access driver	the amount of physical
		registers.	memory installed, and
			replace the adapter.
15	Driver initialized	The driver has	Informational message
	successfully.	successfully loaded.	only.
			No action is required.
16	NDIS is resetting the	The NDIS layer has	Run BACS2 diagnostics;
	miniport driver.	detected a problem	check that the network
		sending/receiving packets	cable is good.
		and is resetting the driver
		to resolve the problem.

152