Fujitsu M4097D manual Operator Panel

Page 17

Operator Panel

The operator panel is located on the upper right hand side of the scanner. The panel consists of an LCD display (16 characters x 2 lines), LEDs and buttons.

Arrangement

Operator panel

Exit

Previous

Stop

 

Enter

 

Send To/

Read

 

Start

 

 

 

 

 

Check

 

Next

 

 

1-5

Image 17
Contents M4097D Image Scanner M4097D Image Scanner Revisions, Disclaimers Page Fujitsu France S.A Fujitsu OfficesPage Preface Conventions Contents GL-1 Activating the Setup Mode Contents of the Setup ModeIN-1 DE-1Terms Index Components Checking the Components M4097D Units and AssembliesFunction Assemblies Operator Panel Button/LED Function Counter Function Counter DisplayOperation status Temporary error Alarm Page Page Chapter describes how to install and connect the scanner InstallationandconnectionsPrecautions Inspection Fujitsu Limited Repositioning the Shipping Lock Cable Connections Connecting the power cableConnecting the interface cables Mounting the Stacker Setting the Scsi ID and the Scsi Terminator Page Page Operatinginstruction Turning the Power On Waking up the Scanner from the Low Power Mode Manual Feed Mode Setting ADF Loading Documents on the ADFMore than 30mm Feed direction ABD Max mm Page Loading Documents on the Flatbed Scanner parts involved when loading documentsLoading Documents Larger than the Document Bed Reading a Page from a Thick Book Page Adfdocumentspecification Scanner Maximum Minimum Document SizePrecautions Paper weightDocument Quality Document typeMore than 30 mm Country Unit Conversion ADF Document Feeder CapacityAreas not to be Perforated Grounding color area Grounding Color AreasDouble Feed Detection Condition Job Separation Sheet Scannerspecifications Specification Remarks Basic Product SpecificationSpecification Installation SpecificationDimensions Page Consumablesandoptions Consumables Name Specification RemarksName Remarks OptionsVideo Interface Option How to Install the Video Interface Option BoardPage AT2 Without IPC With IPC-4D Description OptionParameter Description Parameter Description IPC-4D Option This chapter describes the setup mode of the scanner SetupmodeActivating the Setup Mode Contents of the Setup Mode Scsi ID Setting double feed detection Paper Thickness Setting double feed detection Paper Length Setting IPC pre-set mode Setting the pick start time Reset of the abrasion counterSetting the time-out limit Page IPC Status Display Scsi ID SettingScsi Terminator Setting Low Power Mode Setting Select Interface Select Built-In/IPC-4D Image Processing Display the TPS Board ID NumberIPC-4D Image ProcessingAbrasion counter GlossaryoftermsDensity Front-side reading = Front-side scanning IPC-4D Paper JAM SCSI-ID TPS GL-8 Index LCD Page Declarations of Conformity DE-2 This manual uses recycled paper
Related manuals
Manual 101 pages 26.55 Kb