Fujitsu M4097D manual Setting double feed detection Paper Length

2. Setting double feed detection (Paper Length)

<Screen 42>

1Press or and let the

scanner display Screen 42.

2Press either the or switch to set double feed detection according to paper length. The paper length is checked using the difference between two consecutive sheets of paper fed from the ADF.

Each time either of these switches is pressed,the location of the blinking moves. When the switch is pressed, the blinking moves from (1) to (3). When the switch is pressed, the blinking moves in the opposite direction. However, if the setting by the host computer is valid, the location of the blinking does not move when either switch is pressed.

(1)	“No” is blinking:	Paper length is not checked.
(2)	“Yes” and “1” are blinking:	Paper length is checked. However, a detected double feed
		error is displayed on the screen only; processing is
		continued.

(3)“Yes” and “2: Stop” are blinking: Paper length is checked. When the double feed error is detected, the scan processing is stopped. The error is then reported to the host.

If you want to disable the double feed, select “No” then press . Press to return.

After pressing , the scanner displays the screen 42-1.

<Screen 42-1>

3Press either the or switch to set

double feed detection (paper length).

When the switch is pressed, the blinking moves from (1) to (3). When the

switch is pressed, the blinking moves in the opposite direction.

(1)The “10” is blinking: Threshold is 10mm

(2)The “15” is blinking: Threshold is 15mm

(3)The “20” is blinking: Threshold is 20mm

7-5