Fujitsu M4097D manual

Reading Mode Setting When the Video Interface Option is Installed

This section describes the button specifications and setup details for each of the simplex (front-side), duplex (front-side) and duplex (back-side) reading modes when the scanner has the video interface option in the third party slot.

When the reading mode is set by the command from the host computer, the following button operation is not required.

NOTICE

When the video interface option is installed in the scanner, the scanner automatically recognizes the board and changes the display.

Whenever you press , the scanner returns to screen M1. <Screen M1>

1Turn the power ON and verify that

“Scanner Ready” is displayed on the LCD.

<Screen M2>

2Press then the scanner displays

Screen M2.

3Press then the scanner displays Screen 1.

<Screen 1>

4 Select ADF or FB by pressing or

then press . The scanner displays Screen 2.

<Screen 2>

5Select “Simplex” or “Duplex” by pressing

or . Then press Enter. The scanner displays Screen 3.

6-4