Fujitsu M3093EX, M3093GX manual Revision Record

Page 2

REVISION RECORD

Edition

Date published

Revised contents

01

Dec., 1994

First edition

02

Jan., 1995

Document specification and others changed

03

Apr., 1995

Pick Roller replacement procedure added

04

Septermber, 1995

Pad replacement procedure added

05

January, 1996

Appendix C, Declaration of Conformity added

Specification No.: C150-E022-05EN

This digital apparatus does not exceed the Class A limit for radio noise emissions from digital apparatus set out in the Radio interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’ément pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la classe A prescridtes dans le Réglesment sur le brouillage radioélectrique édicté par le ministere des Communications du Canada.

Maschinenlärmlnformationsverordnung 3. GSGV, 18.01.1991:Der arbeisplatzbezogene Schalldruckpegel beträgt 70 dB(A)oder weniger gemäß ISO 7779.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

The contents of this manual is subject to change without prior notice.

All Rights Reserved,

Copyright ©1994, 1995, 1996 FUJITSU LIMITED

i

Image 2
Contents Image Scanner OPERATOR’S Guide Revision Record Conventions Contents Troubleshooting Figures Tables Preface Differences between the M3093EX and the M3093GXThis page is intentionally left blank Components Checking the ComponentsPart Names and Functions Exterior view of image scannerFunctions of each part Indicator Functions M3093EX/GX IndicatorsInstallation and Connections Precautions× × Removing the Carrier Fixing BracketConnections ⎪ connector to which an ⎪ interface cable is not ⎩ connected Mounting the Stacker SCSI-ID Setting SCSI-ID settingTurning on the Power OperationsReading a Document in Flatbed Mode Reading a standard-size documentFlatbed reading Reading a page from a thick book Reading a document larger than the document board Removing the document coverReading Documents in ADF Mode Section a enlargerd ADF paper chute setting Top For portrait mode Or less Loading the document This page is intentionally left blank Maintenance Removing Jammed DocumentsCleaning Cleaning the ADF Replacing pad ASY Consumables / Periodical replacement partsParts number and replacement cycle Pick Roller replacement Replacing pick rollerMove the Retaining spring Chapter Troubleshooting Check itemsADF Appendix a Installation SpecificationsTable A.1 Installation specifications External Dimensions Figure A.1 External dimensionsTest mode for maintenance Appendix BTable B.1 LED at an error Option IPC-2/CMP-2 option board installationAppendix C Remove the two screws in the following figure Page This page is intentionally left blank Page Page Italy Reader Comment Form