Fujitsu M3093EX, M3093GX manual

Page 44

(9)Where a CMP-2 is installed, remove the screw from the memory board and detach the memory board. Connect the CMP-2 option board connector and tighten the screw.

Screw for IPC-2

IPC-2 option board

CMP-2 option board or memory PCA (M3093GX)

(not shown)

Screw for memor board or CMP-2 (M3093GX)

(10) Attach the power supply and PCA assembly in the reverse order of removal.

C – 3

Image 44

Contents Image Scanner OPERATOR’S Guide Revision Record Conventions Contents Troubleshooting Figures Tables Preface Differences between the M3093EX and the M3093GXThis page is intentionally left blank Components Checking the ComponentsPart Names and Functions Exterior view of image scannerFunctions of each part Indicator Functions M3093EX/GX IndicatorsInstallation and Connections Precautions× × Removing the Carrier Fixing BracketConnections ⎪ connector to which an ⎪ interface cable is not ⎩ connected Mounting the Stacker SCSI-ID Setting SCSI-ID settingTurning on the Power OperationsReading a Document in Flatbed Mode Reading a standard-size documentFlatbed reading Reading a page from a thick book Reading a document larger than the document board Removing the document coverReading Documents in ADF Mode Section a enlargerd ADF paper chute setting Top For portrait mode Or less Loading the document This page is intentionally left blank Maintenance Removing Jammed DocumentsCleaning Cleaning the ADF Replacing pad ASY Consumables / Periodical replacement partsParts number and replacement cycle Pick Roller replacement Replacing pick rollerMove the Retaining spring Chapter Troubleshooting Check itemsADF Appendix a Installation SpecificationsTable A.1 Installation specifications External Dimensions Figure A.1 External dimensionsTest mode for maintenance Appendix BTable B.1 LED at an error Option IPC-2/CMP-2 option board installationAppendix C Remove the two screws in the following figure Page This page is intentionally left blank Page Page Italy Reader Comment Form