Fujitsu M3093GX, M3093EX manual Top For portrait mode Or less

Page 27

5Take documents to be placed in the ADF paper chute. The thickness of the documents to be placed in the ADF paper chute is limited depending on the size of the documents as follows:

A4 or letter size or smaller: 4 mm or less

6Angling the documents

Angle the document edges as follows:

Place the documents face down with the top to the left as shown in A. The long side is the top for landscape mode and the short side is the top for portrait mode.

Lift the documents holding the both ends with both hands.

Hold the documents tightly with your left hand and bend the documents as shown in B.

Grip tightly with your right hand, loosen the grip of your left hand, and straighten the documents as shown in C.

Repeat these operations until the top is angled 20° or less as shown in D.

Top

A

(For portrait mode)

B

D

20° or less

C

4 – 8

Image 27
Contents Image Scanner OPERATOR’S Guide Revision Record Conventions Contents Troubleshooting Figures Tables Differences between the M3093EX and the M3093GX PrefaceThis page is intentionally left blank Checking the Components ComponentsExterior view of image scanner Part Names and FunctionsFunctions of each part M3093EX/GX Indicators Indicator FunctionsPrecautions Installation and ConnectionsRemoving the Carrier Fixing Bracket × ×Connections ⎪ connector to which an ⎪ interface cable is not ⎩ connected Mounting the Stacker SCSI-ID setting SCSI-ID SettingOperations Turning on the PowerReading a standard-size document Reading a Document in Flatbed ModeFlatbed reading Reading a page from a thick book Removing the document cover Reading a document larger than the document boardReading Documents in ADF Mode Section a enlargerd ADF paper chute setting Top For portrait mode Or less Loading the document This page is intentionally left blank Removing Jammed Documents MaintenanceCleaning Cleaning the ADF Consumables / Periodical replacement parts Parts number and replacement cycleReplacing pad ASY Replacing pick roller Pick Roller replacementMove the Retaining spring Check items Chapter TroubleshootingADF Installation Specifications Table A.1 Installation specificationsAppendix a Figure A.1 External dimensions External DimensionsAppendix B Test mode for maintenanceTable B.1 LED at an error IPC-2/CMP-2 option board installation Appendix COption Remove the two screws in the following figure Page This page is intentionally left blank Page Page Italy Reader Comment Form