Fujitsu M3093EX, M3093GX manual Maintenance, Removing Jammed Documents

Page 30

CHAPTER 5 MAINTENANCE

5.1Removing Jammed Documents

5.2Notes on Daily Use

5.3Cleaning

5.4Consumables/Periodical replacement parts

This section explains how to remove jammed documents, and provides notes on daily use and cleaning.

5.1 Removing Jammed Documents

If documents jam while being fed by the ADF, remove the jammed documents as follows:

1Remove the documents from the ADF paper chute.

2Pulling up the ADF lever, open the automatic document feeder.

3Remove the jammed documents.

4Close the ADF until the ADF lever locks.

ADF lever

Automatic document feeder (ADF)

Figure 5.1 Removing jammed documents

5 – 1

Image 30
Contents Image Scanner OPERATOR’S Guide Revision Record Conventions Contents Troubleshooting Figures Tables Preface Differences between the M3093EX and the M3093GXThis page is intentionally left blank Components Checking the ComponentsPart Names and Functions Exterior view of image scannerFunctions of each part Indicator Functions M3093EX/GX IndicatorsInstallation and Connections Precautions× × Removing the Carrier Fixing BracketConnections ⎪ connector to which an ⎪ interface cable is not ⎩ connected Mounting the Stacker SCSI-ID Setting SCSI-ID settingTurning on the Power OperationsReading a Document in Flatbed Mode Reading a standard-size documentFlatbed reading Reading a page from a thick book Reading a document larger than the document board Removing the document coverReading Documents in ADF Mode Section a enlargerd ADF paper chute setting Top For portrait mode Or less Loading the document This page is intentionally left blank Maintenance Removing Jammed DocumentsCleaning Cleaning the ADF Consumables / Periodical replacement parts Parts number and replacement cycleReplacing pad ASY Pick Roller replacement Replacing pick rollerMove the Retaining spring Chapter Troubleshooting Check itemsADF Installation Specifications Table A.1 Installation specificationsAppendix a External Dimensions Figure A.1 External dimensionsTest mode for maintenance Appendix BTable B.1 LED at an error IPC-2/CMP-2 option board installation Appendix COption Remove the two screws in the following figure Page This page is intentionally left blank Page Page Italy Reader Comment Form