Fujitsu M3093EX, M3093GX manual Replacing pick roller, Pick Roller replacement

Page 34

3Insert the pad assembly into the ADF frame hole (the bigger one), slide the assembly to the direction of the arrow until it clicks.

ADF frame

Pad assy

NOTICE: Pad can be replaced by aligning the holes of the pad with the pins of the Pad holder.

5.4.3Replacing pick roller

Replace the pickroller as follows.

Pad holder

Pad

Pick spring

Thumb Screw

Guide A

a.Pull the cap up to open the ADF unit.

b.Remove two thumb screws shown in Figure 5.4. And re- move the Guide A.

Thumb Screw

Figure 5.4 Pick Roller replacement

5 – 5

Image 34

Contents Image Scanner OPERATOR’S Guide Revision Record Conventions Contents Troubleshooting Figures Tables Preface Differences between the M3093EX and the M3093GXThis page is intentionally left blank Components Checking the ComponentsPart Names and Functions Exterior view of image scannerFunctions of each part Indicator Functions M3093EX/GX IndicatorsInstallation and Connections Precautions× × Removing the Carrier Fixing BracketConnections ⎪ connector to which an ⎪ interface cable is not ⎩ connected Mounting the Stacker SCSI-ID Setting SCSI-ID settingTurning on the Power OperationsReading a Document in Flatbed Mode Reading a standard-size documentFlatbed reading Reading a page from a thick book Reading a document larger than the document board Removing the document coverReading Documents in ADF Mode Section a enlargerd ADF paper chute setting Top For portrait mode Or less Loading the document This page is intentionally left blank Maintenance Removing Jammed DocumentsCleaning Cleaning the ADF Parts number and replacement cycle Consumables / Periodical replacement partsReplacing pad ASY Pick Roller replacement Replacing pick rollerMove the Retaining spring Chapter Troubleshooting Check itemsADF Table A.1 Installation specifications Installation SpecificationsAppendix a External Dimensions Figure A.1 External dimensionsTest mode for maintenance Appendix BTable B.1 LED at an error Appendix C IPC-2/CMP-2 option board installationOption Remove the two screws in the following figure Page This page is intentionally left blank Page Page Italy Reader Comment Form