Fujitsu M3093GX, M3093EX manual Move the Retaining spring

Page 35

c.Pinch the retaining spring and slide it toward the roller. Free bearing A from the bracket by sliding it toward the roller.

Bearing A

Retaining Spring

Figure 5.5 Move the Retaining spring

d. Slide the pick roller shaft in the

 

direction of arrow B and remove

 

the shaft from bearing B.

 

The roller shaft can then be lifted

 

and removed as shown in Figure

Arrow B

5.6.

 

e. Remove the bearing B.

 

f. Mount the new pick roller in

 

reverse order of removal.

 

 

Bearing B

Figure 5.6

Slide the Pick Roller

NOTICE: When mounting the Guide A, note that the hooks of the retaining spring are not pressed by the Guide A. (See figure bellow)

Guide A

×

j

Retaining spring

 

 

5 – 6

Image 35
Contents Image Scanner OPERATOR’S Guide Revision Record Conventions Contents Troubleshooting Figures Tables Differences between the M3093EX and the M3093GX PrefaceThis page is intentionally left blank Checking the Components ComponentsExterior view of image scanner Part Names and FunctionsFunctions of each part M3093EX/GX Indicators Indicator FunctionsPrecautions Installation and ConnectionsRemoving the Carrier Fixing Bracket × ×Connections ⎪ connector to which an ⎪ interface cable is not ⎩ connected Mounting the Stacker SCSI-ID setting SCSI-ID SettingOperations Turning on the PowerReading a standard-size document Reading a Document in Flatbed ModeFlatbed reading Reading a page from a thick book Removing the document cover Reading a document larger than the document boardReading Documents in ADF Mode Section a enlargerd ADF paper chute setting Top For portrait mode Or less Loading the document This page is intentionally left blank Removing Jammed Documents MaintenanceCleaning Cleaning the ADF Replacing pad ASY Consumables / Periodical replacement partsParts number and replacement cycle Replacing pick roller Pick Roller replacementMove the Retaining spring Check items Chapter TroubleshootingADF Appendix a Installation SpecificationsTable A.1 Installation specifications Figure A.1 External dimensions External DimensionsAppendix B Test mode for maintenanceTable B.1 LED at an error Option IPC-2/CMP-2 option board installationAppendix C Remove the two screws in the following figure Page This page is intentionally left blank Page Page Italy Reader Comment Form