Fujitsu M3093GX, M3093EX manual Table B.1 LED at an error

Page 41

(2)Activating the continuous operation test

Open the ADF and close it again. If no document is loaded on the ADF within five sec- onds after closing the ADF, the image scanner runs in flatbed mode. If documents are loaded on the ADF within five seconds after closing the ADF, the image scanner continu- ously feeds the document from ADF. Once the image scanner start reading documents in the flatbed mode, it does not feed documents from ADF even if documents are loaded on the ADF.

(3)Ending the test in flatbed mode

To stop the carrier movement in flatbed mode, open the ADF cover. If the ADF cover is opened, the POWER lamp starts blinking immediately after the carrier returns to the home position.

(4)Ending the test in ADF mode

If the ADF document hopper is empty, feeding documents from the ADF ends. To restart feeding, open the ADF cover and close it again. Then load documents on the ADF docu- ment hopper within five seconds after closing the ADF cover.

(5)LED status on error

If an error occurs during the test, the LED indicates as shown in table B.1.

If paper is jammed in the ADF, remove the jam and close the ADF cover. The CHECK lamp stops blinking about three seconds after closing the ADF cover. To feed the docu- ment from ADF, open and close the ADF cover.

Table B.1 LED at an error

Errors

POWER lamp

READ lamp

CHECK lamp

 

 

 

 

Paper jam

On

Off

Blink

 

 

 

 

Carrier unit error

Blink

Off

On

 

 

 

 

Optical system error

Blink

Off

Blink

 

 

 

 

Motor fuse failure

Blink

On

On

 

 

 

 

Lamp fuse failure

Blink

On

Blink

 

 

 

 

B – 2

Image 41
Contents Image Scanner OPERATOR’S Guide Revision Record Conventions Contents Troubleshooting Figures Tables Differences between the M3093EX and the M3093GX PrefaceThis page is intentionally left blank Checking the Components ComponentsExterior view of image scanner Part Names and FunctionsFunctions of each part M3093EX/GX Indicators Indicator FunctionsPrecautions Installation and ConnectionsRemoving the Carrier Fixing Bracket × ×Connections ⎪ connector to which an ⎪ interface cable is not ⎩ connected Mounting the Stacker SCSI-ID setting SCSI-ID SettingOperations Turning on the PowerReading a standard-size document Reading a Document in Flatbed ModeFlatbed reading Reading a page from a thick book Removing the document cover Reading a document larger than the document boardReading Documents in ADF Mode Section a enlargerd ADF paper chute setting Top For portrait mode Or less Loading the document This page is intentionally left blank Removing Jammed Documents MaintenanceCleaning Cleaning the ADF Replacing pad ASY Consumables / Periodical replacement partsParts number and replacement cycle Replacing pick roller Pick Roller replacementMove the Retaining spring Check items Chapter TroubleshootingADF Appendix a Installation SpecificationsTable A.1 Installation specifications Figure A.1 External dimensions External DimensionsAppendix B Test mode for maintenanceTable B.1 LED at an error Option IPC-2/CMP-2 option board installationAppendix C Remove the two screws in the following figure Page This page is intentionally left blank Page Page Italy Reader Comment Form