Inova OnTimeTM owner manual Pendant Mounting Single or Double

Page 10

Inova OnTime Digital Clock Owner's Manual

Pendant Mounting – Single or Double

The following is a recommended procedure for pendant mounting. This procedure requires a mounting kit – Model ONTKIT - and some additional hardware.

Figure 1: Pendant Mounting

1.Determine the clock mounting location.

The illustration above suggests a recommended mounting means for a pendant mount of one or more OnTime Digital Clock. Supplement the ONTKIT with two suitable locknuts and a length of ¾ “ 1.905 cm) pipe or conduit.

2.Mark the location where the clock assembly is to be mounted, making sure that the mounting means is located beneath the data cable outlet.

3.Assemble and tighten the locknuts and pipe length as shown above.

4.Insert about 10 to 12 inches (30 cm) of data cable through the center hole of the mounting kit. Securely attach the mounting means using fasteners suitable for the surface.

5.Lift an OnTime Digital Clock into position and insert the data cable into the jack located on the back of the clock.

6.Position the keyhole slots located on the rear of the clock over the mounting tabs.

7.Pull the clock slightly downwards until the unit is seated.

8.Repeat for the second clock if two clocks are being installed back-to-back.

All claims based on information publicly available at time of printing. All other product or service names mentioned in this document may be

trademarks of the companies with which they are associated. © 2007 Inova Solutions. All rights reserved. 6.12.2007 page 5

Image 10
Contents Inova OnTimeTM Digital Clock Inova OnTimeTM Digital Clock Table of Contents Maintenance Product Warranty Recording Static IP Addresses or Host NamesFigures TablesIntroduction to Inova OnTimeTM Digital Clocks Safety Instructions Technical Specifications Technical SpecificationsONT4 Models ONT6 Models Unpacking and Installation Surface MountingPendant Mounting Single or Double Pendant MountingCantilever Mounting Single or Double Cantilever MountingPage With a clock configuration string. Clocks will Digital Clock ConfigurationConfiguration Method Description Reference Clock Configuration MethodsUsing Dhcp for Addressing and Configuration Configuration PlanningPage Option Name Creating a Dhcp Configuration StringConfiguration Setting Option ValueCommand Description Setting a Different Dhcp Option Number on a ClockVerifying the Dhcp Configuration Settings on a Clock Examples of Common Dhcp Configuration StringsDhcp Configuration Example for Microsoft Server Telnet Configuration Accessing Telnet Command Line and SigningAssigning an IP Address Accessing Help CommandsSetting the Dhcp Address Display ? or help displaySetting the Static IP Address Specifying a Time ServerTesting the Time Server Synchronization Selecting the Time Server Selecting Time ZonesConfiguring AM/PM Indicator Configuring Daylight Saving TimeConfiguring 12/24 Time Format Configuring Colons On/OffTroubleshooting Troubleshooting OnTime Digital ClockRecording Static IP Addresses or Host Names Recording IP Addresses or Host NamesMaintenance Product Warranty Repair and ReturnGlossary of Terms CantileverCondition Appendix a Digital Clock ConfigurationSolution Display ? or help displaySntp -s ArpReboot Configuration Commands NetstatAppendix B Sntp Basics Appendix C Configuring Dhcp Options for Microsoft Servers