Chapter 3 Installing the Switch
Installing the SFP Transceivers
To insert an SFP transceiver into the SFP socket, follow these steps:
Step 1 Attach an ESD grounding strap to your wrist and to ground. (If you are unsure about the correct way to attach an ESD grounding strap, see the “Preventing Electrostatic Discharge Damage” section on page
Step 2 Remove the SFP transceiver from its protective packaging.
Step 3 Check the label on the SFP transceiver body to verify that you have the correct model for your network, and locate the send (Tx) and receive (Rx) markings that identify the top side of the SFP transceiver.
Note On some SFP transceivers, the Tx and Rx marking might be replaced by arrows that point from the SFP transceiver connector (transmit direction or Tx) to the connector (receive direction or Rx).
Step 4 Carefully insert the SFP transceiver halfway into the socket. (See Figure
Step 5 Pivot the SFP transceiver
Figure 3-7 Installing an SFP Transceiver into an SFP Transceiver Socket
1 2
1 | 2 |
1 2
| 1 | 2 |
|
| |
|
| 147985 |
|
| Cisco ME 6500 Series Ethernet Switch Installation Guide |
|