Chapter 4 Removal and Replacement Procedures
Removing and Installing the Fan Tray
Installing the AC-Input Power Supply
To install an
Step 1 Remove the new
Step 2 Loosen the two captive installation screws and remove the blank faceplate (Cisco part number
Step 3 Verify that the power switch is in the off (0) position on the power supply that you are installing.
Step 4 Grasp the power supply handle with one hand, and place your other hand underneath the power supply. Slide the power supply into the power supply bay. Make sure that the power supply is fully seated in the power supply bay.
Note The AC power supply is equipped with an EMI gasket on the top, bottom, and sides (on the front edge) of the power supply. When sliding the power supply into the power supply bay, be careful not to damage the EMI gaskets.
Step 5 Tighten the two power supply captive installation screws.
Step 6 Plug the AC power cord appliance connector (C15 connector) into the
Step 7 Plug the other end of the AC power cord into the source AC outlet.
Step 8 Switch the power supply on/off switch to on. Verify the power supply operation by ensuring that the power supply front panel LEDs are in the following states:
•INPUT OK LED is green
•FAN OK LED is green
•OUTPUT OK is green
As an added check, verify that you can hear the power supply fan operating.
Removing and Installing the Fan Tray
This section describes how to remove and install the fan tray in the Cisco ME 6524 Ethernet switch chassis and contains these subsections:
•Required Tools, page
•Removing the Fan Tray, page
•Installing the Fan Tray, page
Required Tools
You might need a
Cisco ME 6500 Series Ethernet Switch Installation Guide
|
| |
|