Installing the High Speed Fan Tray

Replacing the Fan Tray

To install the high speed fan tray, follow these steps:

Step 1 Hold the fan tray with the fans facing down and the FAN FAIL LED on the right. (See Figure 4.)

Figure 4 Installing the High Speed Fan Tray

Captive installation

screw

48V INPUT 1

INPOUT POWER

GOOD

RTN -48VDC GND

WS-C6500-NEB-FAN2

Captive installation

screw

HIGH SPEED FAN

	LINK	LINK	LINK
		LINK	LINK
	LINK	LINK	LINK
		LINK	LINK
	LINK	LINK	LINK
		LINK	LINK
	LINK	LINK	LINK
		LINK	LINK
	LINK	LINK	LINK
	LINK	LINK	LINK
	LINK	LINK	LINK
	LINK	LINK	LINK
	LINK	LINK	LINK
	LINK	LINK	LINK
	LINK	LINK	LINK
	LINK	LINK	LINK
	LINK	LINK	LINK
		LINK	LINK
	LINK	LINK	LINK
		LINK	LINK
	LINK	LINK	LINK
		LINK	LINK
	LINK	LINK	LINK
		LINK	LINK
	LINK	LINK	LINK
	LINK	LINK	LINK
	LINK	LINK	LINK
	LINK	LINK	LINK
	LINK	LINK	LINK
	LINK	LINK	LINK
LINK		LINK	LINK

LINK LINK LINK LINK LINK LINK LINK LINK LINK LINK LINK LINK LINK LINK LINK LINK LINK LINK LINK LINK LINK LINK LINK

48V INPUT 2

FAN FAIL INPOUT POWER
GOOD
RTN	-48VDC GND
LINK	LINK
LINK	LINK
LINK	LINK
LINK	LINK
LINK	LINK
LINK	LINK
LINK	LINK

LINK

- -

CONSOLE

PWR

MGMT

RESET

STATUS SYSTEM CONSOLE PWR MGMT RESET

X6K-SUP2-2GE

INPUT	FAN OUTPUT
OK	FAIL

INPUT	FAN OUTPUT
OK	FAIL

105068

Step 2 Place the fan tray into the front chassis cavity so that it rests on the chassis, and then lift the fan tray up slightly, aligning the top and bottom chassis guides.

Step 3 Push the fan tray into the chassis until the power connector seats in the backplane and the captive installation screws make contact with the chassis.

Step 4 Use a flat-blade or number 2 Phillips-head screwdriver to tighten the captive installation screws. Step 5 Proceed to the “Replacing the Power Supply” section on page 10 to replace the power supply.

Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note

	78-16162-02	9