Cisco Systems 2940 manual This Side

Chapter 2 Installation

Installing the Switch

Figure 2-5 Installing the Mounting Screws on a Wall

1

2

THIS
	SIDE
		AWAY				FROM
MOUNTING
			SURFACE
	SCREW
P/N		TEM		PLATE
	700-
		17464-01			REV.
						A0
CABLE
		SIDE
			ENTRY

2

3

2

89854

1

2

3

Wall

Screws

Screw template

Step 3 Peel the adhesive strip off the bottom of the screw template.

Step 4 Attach the screw template to the wall.

Step 5 Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2 inch (12.7 mm) hole in the three screw template slots.

Step 6 Insert three screws in the slots on the screw template, and tighten until they touch the top of the screw template.

Step 7 Remove the screw template from the wall.

Catalyst 2940 Switch Hardware Installation Guide

2-10 OL-6157-01