Cisco Systems 2940 manual Connecting to the 100BASE-FX Port, Connecting to a 100BASE-FX Port

Chapter 2 Installation

Connecting to the 100BASE-FX Port

Step 2 Insert the other cable end into an RJ-45 connector on the target device.

Step 3 Observe the port status LED.

The LED turns green when the switch and the target device have an established link.

The LED turns amber while Spanning Tree Protocol (STP) discovers the network topology and searches for loops. This process takes about 30 seconds, and then the LED turns green.

If the LED is off, the target device might not be turned on, there might be a cable problem, or there might be a problem with the adapter installed in the target device. See Chapter 3, “Troubleshooting,” for solutions to cabling problems.

Step 4 Reconfigure and restart the target device if necessary.

Step 5 Repeat Steps 1 through 4 to connect each port.

Connecting to the 100BASE-FX Port

The 100BASE-FX port on the Catalyst 2940-8TF-S operates only in full-duplex mode.

You can connect a 100BASE-FX port to an SC port on another device by using one of the MT-RJ fiber-optic patch cables listed in Table 2-1 on page 2-4. Use the Cisco part numbers in Table 2-1to order the patch cables that you need.

Caution Do not remove the dust plugs from the fiber-optic ports or the rubber caps from the fiber-optic cable until you are ready to connect the cable. The plugs and caps protect the fiber-optic ports and cables from contamination and ambient light.

Follow these steps to connect the switch to a 100BASE-FX device:

Step 1 Remove the dust plugs from the 100BASE-FX port and the rubber caps from the MT-RJ patch cable. Store them for future use.

Step 2 Insert the cable in a 100BASE-FX port, as shown in Figure 2-10.

Figure 2-10 Connecting to a 100BASE-FX Port

SYST

STAT

DPLX

SPD

MODE

1x	2x
		3x
			4x
				5x
					6x
						7x
							8x

9	1
100Base-FX
	SFP

Catalyst

2940 SERIES

89476

Step 3 Insert the other cable end into an SC port on the target device.

Catalyst 2940 Switch Hardware Installation Guide

OL-6157-01 2-15