Chapter 2 Installation
Where to Go Next
The LED turns green when the switch and the target device have an established link.
The LED turns amber while the STP discovers the network topology and searches for loops. This process takes about 30 seconds, and then the port LED turns green.
If the LED is off, the target device might not be turned on, there might be a cable problem, or there might be problem with the adapter installed in the target device. See Chapter 3, “Troubleshooting,” for solutions to cabling problems.
Step 5 If necessary, reconfigure and restart the switch or target device.
Where to Go Next
For information about starting up the switch, see the Catalyst 2940 Switch Getting Started Guide.
If the default configuration is satisfactory, the switch does not need further configuration. You can use any of these management options to change the default configuration:
•Start the device manager, which is in the switch memory, to manage individual and standalone switches. This is an
•Start the Network Assistant application, which is described in the Getting Started with Cisco Network Assistant guide. Through this GUI, you can configure and monitor a switch cluster or an individual switch.
•Use the
For setup instructions that use the CLI, go to Appendix C, “Configuring the Switch with the
•Start an SNMP application such as the CiscoView application.
For information about configuring the switch, see the switch software configuration guide.
Catalyst 2940 Switch Hardware Installation Guide
|
| ||
|
|