Cisco Systems 3030 manual Cisco Catalyst Blade Switch Getting Started Guide

Page 1

Cisco Catalyst Blade Switch 3030

Getting Started Guide

This guide provides instructions on how to install your Cisco Catalyst Blade Switch 3030—hereafter referred to as the switch module—in the Dell Modular Server Chassis and to set up and configure your switch module. The Dell Modular Server Chassis—hereafter referred to as the server chassis—is a system that supports up to ten server modules and up to four Ethernet switch modules. The switch module is installed in one of the chassis I/O module bays on the rear panel of the server chassis.

Also covered in this guide are switch management options and troubleshooting help for the switch module.

For details on the number, types, and the location of the module bays and for additional information on the entire modular server system, see the Dell PowerEdge 1855 Systems User's Guide and the Dell PowerEdge 1855 Systems Installation and Troubleshooting Guide at www.support.dell.com.

For additional installation and configuration information about the switch module, see the Cisco Catalyst Blade Switch 3030 documentation on Cisco.com. For system requirements, important notes, limitations, open and resolved caveats, and last-minute documentation updates about the switch module, see the release notes, also on Cisco.com.

When using the online publications, refer to the documents that match the Cisco IOS software version that is running on the switch. You can order printed copies of the manuals from the Cisco.com sites and from the telephone numbers listed in the “Obtaining Documentation” section on page 1-24.

 

 

Cisco Catalyst Blade Switch 3030 Getting Started Guide

 

 

 

 

 

 

78-17052-01

 

 

1-1

 

 

 

Image 1
Contents Cisco Catalyst Blade Switch Getting Started Guide Taking Out What You Need ContentsCisco Gigabit Ethernet Switch Module Description Cisco Gigabit Ethernet Switch Module Dell Modular Server Chassis Architecture Installing the Switch Module in the Server Chassis 143473 Switch module 3 Release latch Server chassis Connecting through the Switch Module Console Port Configuring the Switch ModuleConnecting through the Switch Module Console Port Connecting through the DRAC/MC Enter ~ Waiting for Post to Complete Completing the Initial ConfigurationTo configure Snmp now, enter yes Line vty 0 Using the CLI Managing the SwitchUsing the Device Manager Other Management Options Installation Warning StatementsConnect to the 10/100/1000 Ports Connect to the Switch PortsConnecting to 10/100/1000 Ports Verify Port Connectivity Resetting the Switch Configuration Troubleshooting Initial Configuration SetupCase of Difficulty Accessing Help Online For More Information Obtaining DocumentationProduct Documentation DVD Cisco.comOrdering Documentation Cisco Product Security Overview Documentation FeedbackEmergencies security-alert@cisco.com Reporting Security Problems in Cisco ProductsCisco Technical Support & Documentation Website Obtaining Technical AssistanceDefinitions of Service Request Severity Submitting a Service RequestObtaining Additional Publications and Information 78-17052-01 Hardware Warranty Terms Duration of Hardware Warranty 78-17052-01