Cisco Catalyst Blade Switch 3030 Getting Started Guide
Installing the Switch Module in the Server Chassis
Step 7 Enter the interface name (physical interface or VLAN name) of the interface that connects to the management network, and press Return.
Enter vlan1 for the interface name at this prompt.
Step 8 To configure the interface, enter Yes after the prompt, and then enter the switch IP address and subnet mask. Press Return.
The IP address and subnet mask shown here are examples:
Configuring interface Vlan1:
Configure IP on this interface? [yes]:
IP address for this interface [10.0.0.1]:
Subnet mask for this interface [255.255.255.0] : 255.255.255.0
Class A network is 10.0.0.1, 21 subnet bits; mask is /21
Step 9 Enter no when the prompt asks you if you would like to enable the switch as a cluster command switch. This switch will be a standalone switch.
Would you like to enable as a cluster command switch? [yes/no]: no
Note Clustering is not supported on the Cisco Catalyst Blade Switch 3030.
You have now completed the initial configuration of the switch, and the switch displays its initial configuration. An example of the output is shown here:
The following configuration command script was created: hostname switch1
enable secret 5 $1$cagJ$e4LP91PNazfdADoNAZm6y0 enable password enable_password
line vty 0 15
password
!
!
interface Vlan1 no shutdown
ip address 10.0.0.1 255.255.255.0
!
interface GigabitEthernet0/1
!
interface GigabitEthernet0/2
. . . (output truncated)
|
| Cisco Catalyst Blade Switch 3030 Getting Started Guide |
|
|
|
|
| ||
|
|
| ||
|
|
|