Cisco Systems 3030 manual 143473

Cisco Catalyst Blade Switch 3030 Getting Started Guide

Installing the Switch Module in the Server Chassis

Note The initial configuration assumes that the switch module was never configured, that it is in the same state as when it was received, and that it is not configured with a default username and password.

Follow these steps to install the switch module into the server chassis:

Step 1 Obtain and make note of this information from your network administrator before you begin the switch module installation:

•Switch IP address

•Subnet mask (IP netmask)

•Default gateway (router)

•Enable secret password (encrypted)

•Enable password (not encrypted)

•Telnet password

•SNMP community strings (optional)

Step 2 Select a chassis I/O module bay in which to install the switch module. Follow the prerequisites listed in the “Dell Modular Server Chassis Architecture” section on page 1-5.

Step 3 Remove the end-cap (blank plug) from the selected bay. Store the end-cap (blank plug) for future use.

Step 4 If you have not already done so, touch the static-protective package that contains the switch module to an unpainted metal part of the server chassis for at least 2 seconds.

Step 5 Remove the switch module from its static-protective package.

Step 6 Ensure that the release latch on the switch module is in the open position (perpendicular to the module):

12x 13x

13x 12x 11x

CON

16x 15x 14x

16x 15x 14x

143473

	Cisco Catalyst Blade Switch 3030 Getting Started Guide
78-17052-01		1-7