Cisco Catalyst Blade Switch 3030 Getting Started Guide
Installation Warning Statements
Step 2 Insert an appropriate cable into the SFP module port. Insert the other cable end into the other device (see Figure 9).
Figure 9 | Inserting the Cable into the SFP Module Port |
CON 
11x
11x
16x 15x 14x 13x
16x
15x
13x
12x
143477
For a list of supported modules, see the release notes on Cisco.com. For detailed instructions on installing, removing, and connecting to SFP modules, see the documentation that came with the SFP module.
Caution Removing and installing an SFP module can shorten its useful life. Do not remove and insert SFP modules more often than is absolutely necessary.
Verify Port Connectivity
After you connect to the switch port, the port LED turns amber while the switch establishes a link. This process takes about 30 seconds, and then the LED turns green when the switch and the target device have an established link. If the LED is off, the target device might not be turned on, there might be a cable problem, or there might be a problem with the adapter installed in the target device. See the “In Case of Difficulty” section on page
|
| Cisco Catalyst Blade Switch 3030 Getting Started Guide |
|
|
|
|
| ||
|
|
| ||
|
|
|