Cisco Catalyst Blade Switch 3030 Getting Started Guide
Managing the Switch
interface GigabitEthernet0/16
!
end
Step 10 These choices appear:
[0]Go to the IOS command prompt without saving this config.
[1]Return back to the setup without saving this config.
[2]Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, save it in NVRAM by selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
Step 11 Disconnect the server chassis serial port or the switch console port from the PC. See the “Managing the Switch” section on page
If you need to rerun the initial configuration dialog, see the “Resetting the Switch Configuration” section on page
Managing the Switch
After completing the initial setup and configuration steps, use the CLI, the device manager, or other management options described in this section for further configuration.
Using the CLI
After setting up and installing the switch in your network, you can enter Cisco IOS commands and parameters through the CLI. Access the CLI either by connecting your PC directly to the switch console port or through a Telnet session from a remote PC or workstation. You can also access the CLI through the server chassis console serial port (see “Configuring the Switch Module” section on page
| Cisco Catalyst Blade Switch 3030 Getting Started Guide |