Cisco Catalyst Blade Switch 3030 Getting Started Guide
Installing the Switch Module in the Server Chassis
Waiting for POST to Complete
Follow these steps:
Step 1 Wait for the switch to complete the
Step 2 Verify that POST has completed by confirming that the System Status/ID LED is off, and the Console LED is solid green or amber. If the switch fails POST because of a misconfiguration or error, the System Status/ID LED blinks green, and the Console LED is off.
Log into the DRAC/MC console to get more details about the failure mode.
POST errors are usually fatal. Call Cisco Customer Support immediately if your switch fails POST.
See item 4 in Figure 1 on page 4 for the location of the System Status/ID LED and the Console LED.
Step 3 Wait for the switch to complete flash initialization. When you see the prompt Press Return to Get Started!, press Return or Enter.
Step 4 Make sure that the System Status/ID LED on the switch module is off and the Console LED is green or amber. This means that the switch module is operating properly.
Step 5 See the “Completing the Initial Configuration” section on page
Completing the Initial Configuration
Follow these steps to complete the setup program and to create an initial configuration for the switch.
Note For information about automatically configuring the switch, see the “Assigning the Switch IP Address and Default Gateway” chapter in the switch configuration guide.
|
| Cisco Catalyst Blade Switch 3030 Getting Started Guide |
|
|
|
|
| ||
|
|
| ||
|
|
|