Cisco Systems PA-2E3 manual 14PA-E3 Serial Port Adapter Installation and Configuration

Checking the Configuration

Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 parity

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 4084 packets output, 1298712 bytes, 0 underruns

0 output errors, 0 applique, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

0 carrier transitions

For Cisco 7100, Cisco 7200, and Cisco uBR7200 series routers, use the show controllers serial command, using arguments such as the slot and port number (slot/port), to display information that is specific to the serial interface hardware. Following is an example of the show controllers serial slot/port command that shows the serial port adapter installed on a Cisco 7200 series router in chassis slot 3:

router# show controllers serial 3/0

M1T-Serial: show controller:

PAS unit 0, subunit 0, f/w version 1-23, rev ID 0x1, version 2 idb = 0x608E3340, ds = 0x608E50C0, ssb=0x608E5A84

Clock mux=0x35, ucmd_ctrl=0x8, port_status=0x25 maxdgram=4474, bufpool=64Kb, 128 particles

TM=down CA=up LC=down line state: up

Serial DTE cable (Display text omitted.)

For a VIP2, use the show controllers serial command, using arguments such as those that specify the slot, port adapter, and port numbers (slot/port-adapter/port), to display information that is specific to the serial interface hardware. Following is an example of the show controllers serial slot/port adapter/interface command that shows serial port 2/0/1 on a one-port PA-E3 installed on a VIP2 in chassis slot 1:

router# show controllers serial 2/0/1 Serial2/0/1

Mx E3(2) HW Revision 0x2, FW Revision 2.42

Framing is g751, Clock Source is Line, Bandwidth limit is 34010. National Bit is 0, International Bits are: 0 0

DSU mode 0

Data in current interval (421 seconds elapsed):

0 Line Code Violations, 0 P-bit Coding Violation 0 C-bit Coding Violation

0 P-bit Err Secs, 0 P-bit Severely Err Secs

0 Severely Err Framing Secs, 0 Unavailable Secs

0 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Severely Errored Secs Total Data (last 1 15 minute intervals):

4 Line Code Violations, 0 P-bit Coding Violation, 0 C-bit Coding Violation,

0 P-bit Err Secs, 0 P-bit Severely Err Secs,

0 Severely Err Framing Secs, 0 Unavailable Secs,

3 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Severely Errored Secs No alarms detected.

(Display text omitted.)

8-14PA-E3 Serial Port Adapter Installation and Configuration