C H A P T E R 8
Configuring the PA-T3 Interfaces
To continue your
•
•
•
•
•
•
•
•
Using the EXEC Command Interpreter, page
Identifying Port Adapter Slot and T3 Interface Port Numbers, page
Shutting Down an Interface, page
Performing a Basic Configuration, page
Configuration Example, page
Customizing the
Configuring Cyclic Redundancy Checks, page
Checking the Configuration, page
If you installed a new
After you verify that the new
•
•
•
•
Protocols you plan to route on each new interface
IP addresses if you will configure the interfaces for IP routing
Use of bridging on the new interfaces
Timing source for each new interface and clock speeds for external timing
For a summary of the configuration options available and instructions for configuring interfaces on the
Configuration commands are executed from the privileged level of the EXEC command interpreter, which usually requires password access. Contact your system administrator, if necessary, to obtain access. (See the “Using the EXEC Command Interpreter” section on page
Configuring the