Cisco Systems PA-T3 manual Shutting Down an Interface, Router# configure terminal

Shutting Down an Interface

Slots in the Cisco 7140 series routers are numbered as shown in Figure 8-6. The fixed LAN interface is slot 0, the fixed WAN interfaces are slots 1 and 2, and the modular port adapter interface is slot 4. Slot 3 is not used. Slot 5 is the service adapter.

Figure 8-6 Port Adapter Slot Numbering—Cisco 7140 Series

Slot 5 Slot 4

BOOT

SM-EC-DS RESET ERROR

5 EN

IRX 155 - MM TX

ENRX

CEL CAR ALM

SLOT 0 SLOT 1

	ACT	ACT
	LNK	LNK
	0	1
FE 0 / 0 FE 0 / 1		155 - MM

RX TX

EN RX

CEL CAR ALM

		PWR
		SYS
CONS	AUX	RDY

7140 - 2MM3

	AC OK
	DC OK
	OTF
0
	AC OK
	DC OK
	OTF	18499
2

Slot 1 Slot 0 Slot 2

Shutting Down an Interface

Before you remove an interface that you will not replace, replace a compact serial cable, or replace port adapters, use the shutdown command to shut down (disable) the interfaces to prevent anomalies when you reinstall the new or reconfigured interface processor. When you shut down an interface, it is designated administratively down in the show command displays.

Follow these steps to shut down an interface:

Step 1 Enter the privileged level of the EXEC command interpreter (also called enable mode). (See the “Using the EXEC Command Interpreter” section on page 8-2 for instructions.)

Step 2 At the privileged-level prompt, enter configuration mode and specify that the console terminal is the source of the configuration subcommands, as follows:

Router# configure terminal

Enter configuration commands, one per line. End with Crtl-Z.

Router(config)#

Step 3 Specify the slot/port address of the first interface that you want shut down by entering the subcommand interface as described in .

Table 8-1	Interface Subcommand Syntax
Platform		Command	Example
Cisco 7200 series or Cisco uBR7200		interface, followed by the type	Router(config)#	interface serial 1/0
		(serial) and slot/port (port adapter
		slot number/0)
VIP2		interface, followed by the type	Router(config)#	interface serial
		(serial) and slot/port (interface	1/1/0
		processor slot number/0)
Catalyst RSM/VIP2		interface, followed by the type	Router(config)#	interface serial 0/0
		(serial) and port adapter slot

number/interface port number (port adapter slot number/0)

Configuring the PA-T3 Interfaces 8-7