Cisco Systems CX-FEIP-2FX= manual Guidelines for Interface Processor Installation and Removal

Page 7

	Guidelines for Interface Processor Installation and Removal
Figure 1	Ejector Levers/Captive Installation Screws on the FEIP (Horizontal
	Orientation Shown)

Interface processor
card slot	Ejector
	Ejector
	lever

Interface processor card carrier guide (black)

a

b

Captive installation screw

c

H1984

Note The FEIP is oriented horizontally in the Cisco 7010 and Cisco 7505 and vertically in the

Cisco 7000, Cisco 7507, and Cisco 7513.

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 7

Image 7

Contents Corporate Headquarters If You Need More Information Document ContentsInstallation Prerequisites Installation PrerequisitesSoftware and Hardware Prerequisites List of Parts and Tools Safety GuidelinesElectrical Equipment Guidelines Safety Guidelines Telephone Wiring GuidelinesPreventing Electrostatic Discharge Damage Guidelines for Interface Processor Installation and Removal Orientation Shown Guidelines for Interface Processor Installation and RemovalFast Ethernet Overview Microcode OverviewParameter Ieee 802.3u 100BaseT Specifications100BASE-FX Multimode 100BASE-FX Single Mode Ieee 802.3u 100BaseT SpeciﬁcationsDTE DTE What Is the Cisco 7000 Series?Cisco 7000 Interface Processor End What Is the Cisco 7000 Series?Cisco 7505 Interface Processor End What Is the Cisco 7500 Series?Cisco 7507 Interface Processor End What Is the Cisco 7500 Series?Cisco 7513 Interface Processor End What Is the FEIP? What Is the FEIP?Fast Ethernet Interface Processor FEIP-2TX LEDs on an Feip Port Adapter Partial Faceplate View Feip LEDs1FE-FX Port Adapter Faceplate View Feip Receptacles, Cables, and PinoutsFeip Receptacles, Cables, and Pinouts 1FE-TX Port Adapter Faceplate ViewPin Description RJ-45 Connector Pinout1FE-FX Duplex SC Connector Pin Out In/Out Description MII Connector PinoutFeip Installation Feip InstallationRemoving an Feip Installing an Feip Installing an FeipAttaching Fast Ethernet Interface Cables Attaching Fast Ethernet Interface Cables Attaching the Ferrite Bead around the RJ-45 Cable Using LEDs to Check Feip Status Using LEDs to Check Feip StatusConﬁguring the Fast Ethernet Interfaces Conﬁguring the Fast Ethernet InterfacesSlot Interface Router# copy running-config startup-config Router# configure terminalRouterconfig# interface fa 1/0/0 Routerconfig-int#ip address 1.1.1.10Routerconfig# interface fastethernet 3/0/0 Configuring Interfaces-Descriptions and ExamplesRouter# sh int fa 3/0/0 Checking the Conﬁguration Using show Commands to Verify the Feip StatusStep Router# show interfaces fastethernet 2/0/0 Using show Commands to Display Interface InformationChecking the Configuration Router# sh int fastethernet 2/0/0Router# show controllers cbus Router# show version System image file is biff/rsp-jv-mz, booted via tftp fromSlot database information Router# show diagUpgrading Feip Microcode Using the ping Command to Verify Network ConnectivityUpgrading Feip Microcode Router# copy tftpvip11-1 slot0vip11-1 Router# show flashTo exit conﬁguration mode, press Ctrl-Z Routerconfig# microcode vip2 flash slot0vip11-1Ordering Documentation Obtaining DocumentationWorld Wide Web Documentation CD-ROMTechnical Assistance Center Contacting TAC by Using the Cisco TAC WebsiteObtaining Technical Assistance Cisco.comObtaining Technical Assistance