Fujitsu Siemens Computers 19T2 Installing an ergonomic video workstation, Connecting the monitor

Page 14

Color monitor 19T2

Installing an ergonomic video workstation

Before you set up your equipment you should select a suitable position for working at the monitor. Please observe the following advices when installing a video workstation.

Window

Avoid direct and reflected glare.

Avoid glare from electric lighting.

edge of desk

 

permissible

permissible

reaching sector

reaching sector

600 mm

600 mm

Position the keyboard where it is easiest to reach.

preferable viewing sector

65°

60°

30°

30°

permissible

65°

viewing sector

 

permissible viewing sector

Position the monitor for

Keep ventilated areas clear.

optimum viewing. The viewing distance to the monitor should be approximately 50 cm.

approx. 90°

approx. 90° and more

Remember to maintain correct posture.

Connecting the monitor

See your PC's operating manual for details of the ports on the system unit.

!

Please note the information provided in the "Safety" section in the chapter "Important

notes" at the beginning of this manual.

 

Do not cover the ventilation openings of the monitor.

If you are assembling monitors beside each other, there must be a minimum distance of 30 cm between monitors of the same constructional type, to avoid image distortion. With different monitors, the distance must be increased, if necessary.

6 - English

A26361-K616-Z100-2-5E19

Image 14
Contents 19T2 Sie haben Page A26361-K616-Z100-1-5E19 Betriebsanleitung Operating Manual Ausgabe Juli 2000 July 2000 editionPage Contents Page Target group IntroductionNotational conventions Further informationSafety Important notesTransport notes Cleaning note19T2Manufacturers notes Energy StarImportant note on power cable For the United KingdomChecking the contents of the consignment Installing an ergonomic video workstation Connecting the monitorData cable Operation of the monitor Switching the monitor onSwitching the monitor off Changing the monitor settings Adjusting the contrast and brightness Operating the OSD menuSetting picture position and size SIZE/CENTER Setting the picture geometry GeometrySetting color temperature and colors Color Setting convergence ConvergenceSetting language for the OSD menu Language Setting monitor options OptionOpen Help menu Help Activating the factory settingsResetting a selected function to the factory setting Resetting all settings for the current input signal Resetting all settings for all input signalsAccessories Storable display modes Electrical data Technical dataDimensions and weight Environmental conditionsPreset operating modes VESA-DDC-compatible VGA interfacePin Meaning Pin assignment D-SUB 15-pinTilting and turning area Possible malfunctions Error handlingSelf-diagnosis Screen display is too small or not centered Two fine horizontal lines wires are visibleMonitor adjustment buttons do not react Picture geometry is defectiveError messages on the screen Humming noise is heard after switch-on